Coverage: Approx 15 to 30m2 per litre Depending on the extent of contamination and dilution rate.
Directions for Use
- Due to the nature of this product, it is very important to avoid skin and eye contact and do not inhale any mist/ vapour. ALWAYS WEAR APPROPRIATE PPE DURING APPLICATION.
- First, dampen the contaminated surface with clean water, then apply Proteger ProShield Masonry Wash, neat or diluted with water up to 1:10. Dilution rate will be dependent on the extent of the contamination.
- Immediately spread the product generously to the surface with a sponge, brush or sprayer. Leave to dwell for 10-15 minutes, scrub the surface with a stiff brush and then wash away with plenty of clean water. Do not allow the product to dry on the surface, in cases of heavy contamination this procedure may need to be repeated also reducing the dilution rate will help.
Proteger ProShield Masonry Wash is not suitable for polished or finely honed stone surfaces which are sensitive to acid, such as cement tiles, limestone, marble, manufactured stone, etc. In case of doubt, test in an inconspicuous area first to determine the suitability. This test is important as permanent damage to acid sensitive surfaces can occur. Surfaces such as chrome, enamel, wood, and other acid sensitive surfaces must be protected against splashes and vapours. Acid containing cleaners can develop vapours which may damage sensitive surfaces.
Storage / Lifespan: Close firmly after each use. Store out of direct sunlight, keep in original container only. Use within 6 months of opening.